Rankin's Springs Public School

Pride in Effort

Telephone02 6966 1206

Emailrankinspr-p.school@det.nsw.edu.au

Year 3 to 6 class demonstration of 3D printer

17 May 2019

3d Printer demonstration by Year 3 and 6

We’re gearing up for Mortimer Shield and Zone Cross Country this week as well as training for the Athletics Carnival happening very soon.

We’re also very busy researching information about the First Fleet, convicts and early Australian colonies so that we can write a great narrative that can be made into a short film.

Before we know it, it’ll be holidays again! I warmly welcome anyone to visit the classroom to see what we have been up to.

Miss Maxwell.

The 3d printer information produced by Year 3 to 6

  • The printer uses a thin reel of plastic. It prints it out layer by layer. by Zoe
  • The 3d printer uses layers to build small and large objects. by Seamus
  • It took about 40 minutes to build a 6cm high human figure. by Harry
  • Objects get designed on the computer, and can then be sent to the printer. by Rilee

Rankin's Springs Public School

General enquiries

Follow us

We would like to pay our respects and acknowledge the traditional custodians of the land and also pay respect to Elders both past and present.

Copyright for this website is owned by the State of New South Wales through the Department of Education. For more information go to https://www.dec.nsw.gov.au/footer/copyright.